Chapter 3: Microsoft Windows 2000, 2003, and XP
72
10. Specify the floppy drive containing the blank disk.
11. Select Next. The adapter drivers and the AT-Setup utility are saved to
the floppy disk. The program displays the message in Figure 31when
the process is complete.
Figure 31. Driver Installation Diskette Completion Message
This completes the procedure for creating a driver installation disk. To
use the diskette to install the driver on a Microsoft Windows 2000,
2003, or XP system, refer to “Running AT-Setup from a Driver
Installation Diskette” on page 66 or “Manually Installing a Driver” on
page 73.
To Next Page
Loading...