13
PCBAs
Alvium USB cameras without a closed housing enable access to PCBAs. Keep
away from camera electronics to avoid damage.
Camera power
Operating the camera beyond the specified range damages the camera.
Cameras are powered over USB. Alternatively, cameras can be powered using
the I/O connector at a maximum input of 5.5 VDC, using a limited power source
(LPS), according to IEC 62368-1: 2014 (Second Edition) with maximum 1.5 A.
The camera is not intended to be connected to a DC distribution network.
• Make sure that USB 3.0 / 3.1 Gen 1 host controller cards, on-board host
controllers, or hubs provide sufficient current supply for the connected
cameras.
• We recommend using powered hubs, especially for multi-camera operation.
•For suitable USB accessories, see the Alvium Cameras Accessory Guide.
To Next Page
Loading...
