Allis-Chalmers 400 Series - Page 2

DEALERS PRE-DELIVERY SERVICE
400 SERIES TRACTORS
NAME _
ADDRESS
PHONE _
DATE DELIVERED _
SERIAL NUMBER_
ENGINE MODEL NUMBER
ENGINE SERIAL NUMBER
THE FOLLOWING PRE-DELIVERY SERVICE HAS BEEN COMPLETED:
ENGINE CRANKCASE FILLED WITH OIL DESIGNATED "SC" OR "SD" - BELOW
40°F.-SAE5W-20orSAE 10-W. ABOVE 40°, SAE 30
BATTERY FILLED TO CHECK RING AND FULLY CHARGED
•BEVEL GEAR BOX AND TRANSMISSION FILLED TO CHECK PLUG WITH SAE 90
OIL
ON HYDROSTATIC MODELS HYDROSTATIC PUMP RESERVOIR FILLED TO
CHECK PLUG WITH DEXRON A.T.F.
GREASE FITTINGS LUBRICATED
SET FRONT TIRE PRESSURE TO 10 PSl
SET REAR TIRE PRESSURE TO 8 PSI
ENGINE SPEED SET TO 1700 RPM LOW IDLE AND 3600 RPM AT FULL THROTTLE
BRAKE AND CLUTCH ADJUSTMENT CHECKED
MOWER INSTALLED AND LEVELED
PTO CLUTCH ADJUSTED
. OPERATION OF TRACTOR AND MOWER CHECKED
APPEARANCE TOUCHED UP AS NEEDED
OPERATORS MANUAL WITH TRACTOR
DEALERS SIGNATURE.
DATE
YOUR TRACTOR HAS BEEN ADJUSTED AND SERVICED BY DEALER PRIOR TO ITS DELIVERY TO YOU.