Allis-Chalmers 400 Series - Transmission and Chassis Lubrication

Lubrication and Service
FIGURE 9 - Parts Removed For Clarity
BEVEL GEAR HOUSING (Figure 9)
The bevel gear housing has a capacity of 1 pint of SAE 90
transmission oil and is filled at the factory. Oil level
should be checked every 25 hours operating time by
removing oil fill and level plug. Oil level should be
visible at the bottom of pipe elbow. Add oil if required
but do not raise the level up into the upper part of
elbow. If too much oil is put in it may be ibrown out
of vent plug in top of box. There is a drain plug on
lower part of rear box cover plate from which excess oil
can be drained.
GREASE FITTINGS
There are 5 grea^ fittings on all 400 Series tractors
which should be lubricated every 25 hours of operating
time. They are located as follows:
STEERIMGGEAR
grease fitting
jLIFTASSEMBLYfll
GREASE FITTING
FIGURE 10 - View From Under Tractor
2fittings on front axle (right hand shown) (Figure?)
1 fitting on clutch brake pedal - (Figure 7)
1 fitting on steering gear under tractor - (Figure 10)
1 fitting on lift assembly under tractor - (Figure 10)
Wipe fittings clean before greasing. Use a standard
grease gun with general purpose automotive grease.
FIGURE 11
15