Allis-Chalmers 400 Series - Page 42

ELECTRIC CLUTCH PULLEY
TRACTOR FRONT HITCH
HEIGHT ADJUSTING LEVER
MOWER LINK ASSE MBLY:
MOWER DRIVEN PULLEY!
RIGHT HAND IDLER PULLEY
WING NUT
LIFT CHAIN
”-^WING NUT ROD
INDICATOR
FIGURE 4
FIGURE 3
3. Loosen belt tightening wing nut on front of tractor
and remove drive belt from idler pulleys and
electric clutch pulley on engine.
4. Remove pins and lock pins holding mower link
assembly to tractor front hitch and lower front
of mower to ground.
REMOVING MOWER FROM TRACTOR
Referring to Figures 1 through 4;
1. Park tractor and mower on level ground with
sufficient space to right side of tractor for the
mower.
2. Lower tractor lift and disconnect lift link from
lift arm. Move the mower height adjusting lever
fully forward to put mower in lowest position.
5. T urn tractor wheels fully to left and slide mower
out to right side of tractor.