Operating the Tractor
Attaching a Trailer
The maximum horizontal drawbar force allowed is 280
Nm. The maximum vertical drawbar force is 160 Nm.
This equates to a 250 lbs (113 kg) trailer on a 10 degree
hill. Secure the trailer with an appropriately sized clevis
pin (A, Figure 8) and clip (B).
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the SAFETY
RULES AND INFORMATION section, then perform the
following steps:
• Disengage the PTO, set the parking brake, & remove
the key.
• Perform engine maintenance and storage measures
listed in the Engine Manual. This includes draining
the fuel system, or adding stabilizer to the fuel (do not
store a fueled unit in an enclosed structure - see
WARNING).
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the nega-
tive cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in the Engine Manual.
• Allow the engine to warm up for several minutes
before use.
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
Figure 8. Trailer Weight Recommendations
A. Clevis Pin
B. Clip
A
B
Figure 7. Raising & Lowering Mower
A. Mower Lift Lever
A
Adjusting Mower Cutting Height
The mower lift lever (A, Figure 7) controls the mower cut-
ting height. The cutting height is has seven positions
between approximately 1-1/4” and 4” (3,2-10 cm).
17
To Next Page
Loading...
