Programming Keytis remote controls:
If the installation already comprises other io-homecontrol® products with at least one programmed remote control then
you must perform the Memorising the system key step before programming the remote controls
If the Keytis io remote control to be programmed is the system’s first remote control, then go straight to Programming
the Keytis remote control step
The operations for memorising the system key and to program a remote control by copying another Keytis remote
control are only possible at the installation location. To gain authorisation to transfer its system key or its programming,
the previously programmed remote control must be able to establish radio communication with an installation receiver.
Memorising the system key:
With a Keytis, Telis, Impresario, Composio remote control: press the “KEY” button until the green indicator comes on
(two seconds)
With another remote control: refer to its documentation
Briefly press the “KEY” button on the new remote control. Wait for the confirmation beep (a few seconds)
Programming the Keytis remote control:
Before programming the remote control, make sure that it has already memorised the system key
Each control button is programmed individually
A button that is already programmed cannot be programmed on a second receiver. To see if a button is already
programmed, press it
button programmed → green indicator comes on
button not programmed → orange indicator comes on
Programming from a Dexxo Pro motor:
1. Press the “PROG” button on the Dexxo Pro until the light comes on (two seconds)
2. Briefly press the “PROG” button on the remote control.
3. Wait for the second beep and for the green indicator to start blinking quickly. This may take from a few seconds
to around a minute depending on the number of products connected to the system
To Next Page
Need help?
General
