Allora 2
53
10.9.3 Standby after
If not used for a certain period of time, the Allora automatically switches to a
mode in which the power consumption drops significantly in order to preserve
the battery life. This mode is called the standby mode.
The Standby after parameter defines how many minutes of inactivity need to
pass by before the Allora will automatically go into the stand by mode.
Note that going into Standby mode can also be achieved by pressing the on/off
key briefly.
The Allora wakes up from standby mode as soon as you hit a key.
10.9.4 Shutdown after
With this parameter you can define after how may hours the Allora needs to shut
down automatically.
After automatic shut down you need to restart the Allora with the on/off switch.
10.9.5 Status bar
When set, the Allora will show the status parameters on the right side of the
screen. The status parameters are:
Battery, Mute, FN and Shift key status, messages, SMS mode, signal strength.
10.9.6 Abbreviations
Set this parameter on to automatically expand abbreviations that have been
stored.
10.9.7 Recording with noise filter
If you want to make a recording in a noisy environment, setting on the noise
filter to on can result in a better recording.
10.9.8 Read Stored msg
If you have stored messages under a key, you can recall them by pressing the
message key and the corresponding key. The message will then be
displayed on screen. When the parameter Read Stored msg is ‘on’ this message
will also be pronounced automatically.
10.9.9 Star
The Allora has a special key, the star key that allows you to start your
favorite application. Choose one of the following:
• <None>
• Recording: to make a sound recording
• New SMS: to make a new text message
• Read SMS: to read a text message
• IR send: to send an environmental control command
• Read Time: to read the time
• Recording (A): to hear the recording under character A
• Message (A): to hear the message under character A
To Next Page
Loading...