Need help?Do you have a question about the Allot SG-9100 V2 and is the answer not in the manual?
Procedure for connecting the SG-9100 to the network using bypass units and interface settings.
Steps and considerations for setting up active redundancy between two SG-9100 units.
Methods for identifying the SG-9100 revision and accessing it via physical ports, TSM, or XCC/BMC.
Commands and procedures for configuring IP addresses, gateway, DNS, and passwords on the SG-9100.
Detailed technical specifications comparing SG-9100 V1 and V2 models.
Safety guidelines and classifications related to laser devices used in the SG-9100 components.
General| Power Supply | Dual, Redundant Power Supplies |
|---|---|
| Policy Enforcement | Yes |
| DPI (Deep Packet Inspection) | Yes |
| Security Features | Firewall, IPS |
| Redundancy | Yes |
To Next Page
