Allsteel Terrace DNA User Manual (English)

To Next Page

343-2537 A

Terrace DNA Installation Packet

ASSEMBLY INSTRUCTIONS

Step 1- Remove top cap & install segment bars

Step 2 – Install Upper and Lower shrouds.

Position the top shroud first between panel vertical

members. Have helper holder upper shroud while

installing lower. Note: side with small channel is where

the glass is placed (outside position.)

A. Position shroud so that cut outs on end go

through the vertical upright

B. At approx 40 degrees, maneuver opposite end

of shroud so that its cut outs are aligned w/

vertical upright.

C. Squeezing the shroud on the opposite end

will aid in installation of horizontal shroud.

D. Complete motion by sliding upper shroud

into place (have assistant hold while lower

is installed).

With top shroud in place, maneuver lower shroud so

that one corner is in upper position as shown. This will

allow clearance for the lower portion to fit through

verticals.

Need help?

Do you have a question about the Allsteel Terrace DNA and is the answer not in the manual?

Allsteel Terrace DNA Specifications

General