Alma FLEXICOMPT AUTONOME+ - Connected Features and Supply of the FLEXICOMPT AUTONOME+; Connected functions; Power supply; Configuration, Settings and Calibration

MEANING OF SYMBOLS
Optional action (depends on configuration choosen)
Mandatory action
Event during delivery
Action by operator
GU 7033 EN I
FORM DOC 124 A
UNLOAD A PRODUCT
3. CARRY OUT THE UNLOADING
4. FINISH THE UNLOADING OF A PRODUCT
1. CONNECT THE FLEXICOMPT AUTONOME+
START THE UNLOADING
16
L
Install the FLEXICOMPT AUTONOME+ on the compartment
valve (respect the slope and rotation angles – see picture
on page 1)
2. PREPARE THE UNLOADING
CHOOSE THE PRODUCT
The choice of the
product is validated
when metering starts
0
L
GASoiL
0
L
unLE_LS
GASoiL
*
* last unloaded product
RESET THE METER
ErASinG
0000000
Open the valve
0
L
GASoiL
5. REMOVE THE FLEXICOMPT AUTONOME+
Disconnect the hose between the FLEXICOMPT
AUTONOME+ and the reception tank
Remove the FLEXICOMPT AUTONOME+ from the
compartment valve
CHECK THE CHOSEN PRODUCT
INTENTIONAL INTERRUPTION OF THE UNLOADING
THE COMPARTMENT IS EMPTY
The unloading may be interrupted by several situations
2001
L
Close the valve
Wait the blinking display
End the unloading (§4)
Continue with another
compartment by moving the
FLEXICOMPT AUTONOME+ (§3)
The unloading may be interrupted at any time by
closing the valve
5000
L
GASoiL
End the unloading (§4)
Continue with another
compartment by moving the
FLEXICOMPT AUTONOME+ (§3)
Close the valve
Alarm
GAS
980
L
Alarm
Validate the fault with
See list of alarms page 4
APPEARANCE OF A FAULT AND DISPLAY OF AN ALARM
DISPLAY THE DELIVERY INFORMATION
13,4
°C
41,6
m
3
/h
Instantaneous flowrate
Temperature (with active option)
0
L
diESEL
0
L
unLEAdE
Current volume
(0 if reset with RAZ)
GASoiL
Clean the filter if necessary
6. END THE DELIVERY
Put back the FLEXICOMPT AUTONOME+ in its box
0
L
0
L
or
volume at temperature:Vm
converted volume:Vb
...
1 - Continue with another compartment with the same product
(§3)
2 - Continue with another compartment with another product:
end the unloading (§4) and start a new one (§1)
3 - End the unloading: reset the meter (§4), remove the
FLEXICOMPT AUTONOME+ (§5) and end the delivery (§6)
WHAT DO YOU WANT TO DO?
Connect the hose between the FLEXICOMPT AUTONOME+
and the reception tank
If it’s used with Adblue, the FLEXICOMPT AUTONOME+
must be rinsed with water after use in order to clean it
and to ensure it works properly
SAvinG
0000000
If data recording is automatic, appearance of flowrate causes
a display test and resets the volume to zero.
RESET THE METER
RAZ du volume
NOTE: The unit of flowrate and volume depends on the
settings chosen.