Alma FLEXICOMPT AUTONOME+ - User Manual

FORM DOC 120 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 1/42
This document is available on www.alma-alma.fr
USER MANUAL
MU 7033 EN M
FLEXICOMPT AUTONOME+
M 2020/05/18
How to improve battery life,
Add menus Supervisor>Date format and
Supervisor>Maintenance>Reboot,
Functional changes and improvements
DSM SH
L 2020/01/27 UNI-2 [PJV158] DSM SH
K 2017/10/30
Update table of alarms [MDV568]
GU 7110 cancels and replaces FM 8012 [MDV544]
MU 7087 Mobile printer kit non ATEX
Drawings update
DSM XS
A 2010/04/29 Creation DSM XS
Issue Date Nature of modifications Written by Approved by
Document applicable for software 449+v1.00

Summary

Connected Features and Supply of the FLEXICOMPT AUTONOME+

Connected functions

Wireless communication capabilities and data transfer.

Power supply

Details on the UNI-2 device's rechargeable batteries and charging.

Configuration, Settings and Calibration

Configure the FLEXICOMPT AUTONOME+

Steps for initial setup and metrological controls of the device.

Set the FLEXICOMPT AUTONOME+

Configuring external connections and active interfaces.

Calibrate the FLEXICOMPT AUTONOME+

Procedure for calibrating the measuring system.

Ignition and Operation

Use the FLEXICOMPT AUTONOME+: User Mode

List of alarms

Information on displayed alarms and fault handling procedures.

Configure the FLEXICOMPT AUTONOME+: Metrological Mode

Maintenance

UNI-2 calculator-indicator device

Alma FLEXICOMPT AUTONOME+ Specifications

General

Type	Gas Detector
Gases Detected	O2, CO, H2S
Sensor Type	Electrochemical
Alarm Type	Audible, Visual, Vibration
Ingress Protection	IP67
Measurement Principle	Electrochemical
Measurement Range	O2: 0-30% Vol., CO: 0-1000 ppm, H2S: 0-100 ppm
Resolution	O2: 0.1% Vol., CO: 1 ppm
Display	LCD