Alma FLEXICOMPT AUTONOME+ - Configure the Flexicompt Autonome+: Metrological Mode; Menu References; Menu Config; Sub-Menu Scales

FORM DOC 011 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 21/42
This document is available on www.alma-alma.fr
7 CONFIGURE THE FLEXICOMPT AUTONOME+: METROLOGICAL MODE
Meas. System
Config.
References
Date time
Setup should be done under cover, metering off, with dry gas detectors.
NOTE: Only approved persons are permitted to change parameters
The configuration parameters can only be modified by pressing the micro BP Metro on the
electronic board.
Exit the METROLOGICAL mode by pressing the micro BP Metro. The UNI-2 resets.
The option to display the volume (volume in metering conditions or volume converted to base
conditions) is made in menu Meas. System>Temperature>Vol. disp. when the temperature is
activated.
7.1 Menu References
References
Device
Turbine
Meas. System
Device : Set the serial number of the UNI-2
Turbine : Set the serial number of the turbine meter
Meas. System : Set the serial number of the FLEXICOMPT AUTONOME+
7.2 Menu Config.
Config.
Scales
Products
7.2.1 Sub-menu Scales
Scales
Vol. Units
Vol. Digits
Flowrates