FORM DOC 120 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 7/42
This document is available on www.alma-alma.fr
Communication modules are listed below:
•
Bluetooth Low Energy 4.1 or Wi-Fi (IEEE 802.11 b/g/n (2.4GHz)
They are used for outsourcing of measurement data and parameters of the FLEXICOMPT
AUTONOME+ for the customer. The customer uses a local interface that can be one of his
tools or a tool supplied by ALMA. These features are exclusive.
•
GPS. It is used to locate measurements and synchronize the clock again.
2.2 Power supply
The UNI-2 is powered by two rechargeable batteries. These internal batteries have a five
years lifetime. The FLEXICOMPT AUTONOME+ operates with or without its charging module.
It has at least one week battery life.
To charge the battery, use only the USB cable and the charging module ALMA Wireless
charger, supplied with the equipment.
Charge batteries outside potentially explosive area
To save battery life:
•
The Bluetooth or Wi-Fi connection are activated manually in the menu
Interfaces
of the
USER mode.
•
Wi-Fi cannot work with Bluetooth or GPS
•
Lighting is inhibited when Wi-Fi is enabled
•
The communication modules are automatically switched to standby after a period of
inactivity.
•
The GPS turns on automatically during measurements only
To set date and time, you can switch on the GPS manually to synchronize the clock again.
This operation lasts one minute and must be done outdoors. Turn of the GPS at the end of
synchronization (see
Connect>Start GPS
).
3 CONFIGURATION, SETTINGS AND CALIBRATION
3.1 Configure the FLEXICOMPT AUTONOME+
You must configure the FLEXICOMPT AUTONOME+ during commissioning and sometimes
during metrological controls. Break the seals protecting the opening of the case, remove the
four screws and press the micro BP Metro. See below.
Then you enter the METROLOGICAL mode. Details are available in the section CONFIGURE
THE FLEXICOMPT AUTONOME+: METROLOGICAL MODE.
NOTE: Only approved persons are permitted to remove the seal.
ALMA Wireless charger