FORM DOC 120 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 8/42
This document is available on www.alma-alma.fr
3.2 Set the FLEXICOMPT AUTONOME+
You must set the FLEXICOMPT AUTONOME+ before use. Then choose:
•
Menu
User>Connect
to enable the possible external connections
•
Menu
User>Interfaces
to set the active connections
3.3 Calibrate the FLEXICOMPT AUTONOME+
To calibrate the FLEXICOMPT AUTONOME+, choose the menu
User>Supervisor>Calibration
.
To modify the coefficient, remove the seal to switch in METROLOGICAL mode.
NOTE: Only approved persons are permitted to remove the seal.
4 OPERATING RECOMMENDATIONS
The operating temperature of the UNI-2 is between -20°C and +50°C.
When it is not used, it’s better to close the UNI-2 cover.
The front face glass must be regularly cleaned for easy readability and better communication
with the CTD+.
Charge batteries outside potentially explosive area
Replace batteries outside potentially explosive area
Use the CTD+ outside potentially explosive area
Micro BP Metro
To Next Page
Loading...