FORM DOC 011 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 12/42
This document is available on www.alma-alma.fr
6.1.1 Data recording and volume reset
Data recording and volume reset depend on the configuration of the FLEXICOMPT
AUTONOME+:
Manual recording sequence: volume reset and recording of the last
measurement data are triggered by pressing RESET at zero flow conditions
Automatic recording sequence: the appearance of flowrate resets the volume to
zero. The last measurement data are recorded when the time-out is up.
6.1.2 Transfer measurement results and parameters
6.1.2.1 Transfer with the INSIDE app
The INSIDE app is used to transfer measurement results and parameters. See
the user guide GU 7094.
6.1.2.2 Transfer with CTD+
The CTD+ is not ATEX, this operation must be done outside potentially
explosive area.
When flow rate is zero, you can transfer to the key the parameters and the
measurement results of the N last days. Set N in the menu
User>Interfaces>CTD+
See the user guide GU 7110
The file can be downloaded to a PC at '.csv' format.
NOTE: Do not plug the USB cable during data transfer.
6.1.3 Printing
6.1.3.1 Printing with the INSIDE app
Use the INSIDE app to print the delivery ticket. This feature is used to print
delivery ticket as a PDF file. See the user guide GU 7094.
6.1.3.2 Printing with the CTD+ and the mobile printer kit
Use the CTD+ and the non ATEX mobile printer kit to print the delivery ticket.
See the user manual MU 7087.
6.2 Menu Connect
Connect
Start BT or Stop BT
Start WiFi or Stop WiFi
Start GPS or Stop GPS
Start BT
: Start or stop Bluetooth connection. The Bluetooth switches automatically to
stand-by mode after two minutes of inactivity when connection is off and after ten
minutes of inactivity when connection is on
Start Wi-Fi
: Start or stop Wi-Fi connection
Start GPS
: This menu is used to switch on the GPS manually to synchronize the clock
again. This operation lasts one minute and must be done outdoors. Stop GPS at the
end of synchronization.
To Next Page
Loading...