FORM DOC 011 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 33/42
This document is available on www.alma-alma.fr
Put the grain (37) in its place on the turbine body and press the washer (38)
against the grain (37)
Put the spacer on the input of the turbine body so that the cable faces the wires
pass through and that the threaded rod (29) goes through the 2DLA01-spacer
8.3.5 Assembling the upstream coupling
Put the upstream coupling (40) with the handle seat (16) on the 2DLA01-spacer
Position the upstream coupling (40) so that in use the downstream coupling is in
the lowest position than the upstream coupling
Screw the 3 screws (18). They must be lubricated with Molybdenum grease
Put the washers (31) and (32) on the threaded rod (29) and screw the nut (30)
Put the lead seal cup (33) and the screw (34) on the threaded rod (29)
Seal the lead seal cup* (if necessary)
40
16
18
33
34
29
31 32
15
37 38
39
39
29
29
30
To Next Page
Loading...
