Alma FLEXICOMPT AUTONOME+ - Removing the 2 DLA01-Spacer from the Turbine; Setting of the New 2 DLA01-Spacer

FORM DOC 011 A
MU 7033 EN M
FLEXICOMPT AUTONOME+
Page 32/42
This document is available on www.alma-alma.fr
 Unplug the 6 wires of the 2DLA01-spacer from the terminal block B2 (see Picture
A)
Picture A
8.3.3 Removing the 2DLA01-spacer from the turbine
 Remove the 2DLA01-spacer (15) from the turbine body
 Keep by your side the ring (37) and the washer (38) of the 2DLA01-spacer cable
8.3.4 Setting of the new 2DLA01-spacer
 Grease the rings (39) of the turbine body and the 2DLA01-spacer (translucent
grease for food contact)
 Put back the washer (38) and the ring (37) on the cable of the new 2DLA01-
spacer
 Pass the 6 wires and then the cable through the wires pass through of the turbine
body
15
37
38
Terminal block B2
B29.B28.B27.B26.B25.B24