To Next PageTo Next Page
Need help?Do you have a question about the Alogic Clarity Pro and is the answer not in the manual?
General| Screen Size | 27 inches |
|---|---|
| Panel Type | IPS |
| Response Time | 5 ms |
| Brightness | 350 cd/m² |
| Contrast Ratio | 1000:1 |
| VESA Mount | 100 x 100 mm |
| Speakers | Yes |
| Resolution | 2560 x 1440 (QHD) |
| Refresh Rate | 75Hz |
| Viewing Angle | 178°/178° |
| USB-C Power Delivery | 65W |
| Speakers Wattage | 2 x 2W |
| Connectivity | HDMI, DisplayPort, USB-C |
| Color Gamut | 99% sRGB |
| Ports | 1 x HDMI, 1 x DisplayPort, 1 x USB-C |
Indicates the power is on and the monitor is operating normally.
Indicates no video source, invalid signal, or low voltage.
Connect the included power cable to the power connector, and then plug the other end into a wall outlet.
Connect a computer or other source device using HDMI, DisplayPort, or USB-C cables.
Connect headphones or external speakers to the audio output jack.
Switches between video inputs.
Adjust the Brightness, Shadow Balance and Contrast.
Adjust the monitor's Saturation, Sharpness and Gamma.
Adjust your monitor's colour temperature.
Enables the monitor's HDR mode for more vivid colours.
Display video from two sources at once.
Automatically switch between portrait and landscape modes.
Manage monitor firmware, USB device power, and port selection.
Mute or adjust the volume of the monitor's speakers.
Reset your monitor to factory default settings.
