Alpha Digital LD353 - Initial User Settings; Set the date and time; Recorder Recording Operations; Automatic and manual recording

7
Set the date and time:
1. Because the machine has switched the camera's automatic functions, you
need to press the OK button click, the device enters the standby state.
2. Then press the M button twice, at <time/date>by pressing or to
select <date/time>, then press the ok button to enter the setting.
3. By press the or keys to adjust the value, press the OK button to enter
another field. Until the completion date and time settings, press M to exit.
Recorder Recording Operations
1. When the car engine is started, the device is automatically turned on and start
recording. When the engine stalled, then it will automatically stop recording.
Or press the OK button. Way manually stop recording.
Note: some vehicles powered car charger interface is often when the engine
stalled, the power supply will continue to work. If you encounter such a situation,
take the following steps: Open the manual way on/of the device, or the car
charger from a car cigarette lighter port unplugged.
2. Other types of camera: Press the OK button, then start recording; press the OK
button again, then stop recording.
Note: (1)1,2,3,4,5,10 minutes every camera, it will save time, please refer to the
circulation camera menu.(2)The equipment will be saved in the camera memory
card, if a memory card is full, the oldest file is automatically overwritten memory
card.
3. Emergency camera
Note: if you start a gravity sensor, and detect a collision, the device will
automatically lock the current record video will not be overwritten.
Initial user settings