EasyManuals Logo

Alphacool Core User Manual

Alphacool Core
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background image
2.
Switch off the computer. The power switch
does NOT turn off the power supply to the
computer. To cut off the power supply to the
computer, you must unplug the power cord
from the wall socket. Make sure the power
cord is unplugged before opening the
computer chassis.
Schalten Sie den Computer aus. Der
Netzschalter schaltet die Stromversorgung
des Computer NICHT aus. Um die
Stromversorgung des Computer zu
unterbrechen, müssen Sie das Netzkabel aus
der Steckdose ziehen. Vergewissern Sie sich,
dass das Netzkabel herausgezogen ist, bevor
Sie das Computer Chassis öffnen.
Éteignez l'ordinateur. L'interrupteur
d'alimentation ne coupe PAS l'alimentation de
l'ordinateur. Pour couper l'alimentation de
l'ordinateur, vous devez débrancher le câble
d'alimentation de la prise de courant.
Assurez-vous que le cordon d'alimentation
est débranché avant d'ouvrir le châssis de
l'ordinateur.
Alphacool
Core 6x 4-Pin PWM/DRGB splitter with SATA power
connector
Accessories Zubehör Accessoires
1x
aRGB Mainboard Cable / aRGB Mainboardkabel /
Câble de carte mère aRGB
1x
Velcro fastener / Klettband / Fermeture velcro
1x
4 pin PWM Cable/4-poliges PWM-Kabel/Câble
PWM 4 broches
Note Hinweis Remarque
Mounting Montage Montage
Mount the distributor Verteiler montieren Monter le distributeur
1.
EN DE FR
1. Remove the upper protective lm of the
adhesive tape and stick it under the
Controller.
2. Now remove the second protective lm of
the adhesive tape and stick the Controller to
the computer case as shown. The Controller
can be detached again through the Velcro
layer.
1. Entfernen Sie die obere Schutzfolie des
Klebebands und kleben Sie sie unter den
Controller.
2. Entfernen Sie nun die zweite Schutzfolie
des Klebebands. Kleben Sie den Controller
wie dargestellt, am Computergehäuse fest.
Durch die Klettschicht lässt sich der
Controller wieder lösen.
1. Retirez l’une des feuille de protection du
double velcro adhésif et collez la partie
adhésive ainsi exposée sous le controlleur.
2. Retirez maintenant la deuxième feuille de
protection du ruban adhésif. Collez le
contrôleur sur le boîtier de l'ordinateur
comme indiqué. La couche de velcro permet
de détacher le contrôleur.
Lisez les instructions de sécurité avant de commencer l‘installation.FR
DE Lesen Sie die Sicherheitshinweise, bevor Sie mit der Installation beginnen.
EN Read the safety instructions before starting the installation.
Safety instruction
Sicherheitshinweis
Avis de sécurité

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alphacool Core and is the answer not in the manual?

Alphacool Core Specifications

General IconGeneral
BrandAlphacool
ModelCore
CategoryMedia Converter
LanguageEnglish

Related product manuals