(3) Press to activate your selection. The alarm is now set to alert every day at this
specified time.
2.11 Private Time
You can select a time period during which your pager is completely silent. Your pager
still receives messages but is does not alert. The pager alerts only if an alarm expires
or a priority message is received.
2.11.1 Set Private Time
(1) From the Function menu, press ▲ to move the cursor to .
(2) Press .
When the Private-time screen is first displayed, the cursor is at the flashing symbol on
the far left, indicates private time is enabled, indicates private time is disabled.
Example of Set Private-Time Screen
(3) Press and release until is displayed.
(3) Press ▼ to move the cursor to the hour digit.
(4) Press to adjust the hour digit.
(5) Repeat steps 4 and 5 to adjust the on and off time setting.
(6) Press to activate you selection.
The symbol is displayed in the Standby screen when private time is enabled.
Note: If the on time is equal to the off time, private time is not enabled.
2.11.2 Disable Private Time
(1) Press .
(2) Press ▲ to move the cursor to .
(3) Press .
(4) Press and release until is displayed.
(5) Press to disable private time.
2.12 Stopwatch function
From the Function menu, press ▼ to move the cursor to , Press to activate
stopwatch function.
start counting, again to stop counting. ▲ or ▼ to reset , to quit.
3. Notebook
Your pager has a personal notebook for storing personal messages, From standby
menu move shade to Notebook directory, press to enter. .
Example of Notebook
To Next Page
Loading...
