Alpine 3D Shuttle 7980M - Page 15

Auto Memory Preset
1. Press the TUNE switch @ to light up the A. MEmo indicator @2.
2. Select the desired tuning band (FM1, FM2, MW or LW) with the TUNER/BAND button
©.
NOTE:
The Auto Memory Preset procedure is allowed in the D.A.P. Mode.
3. Press the UP @ or DN @ switch. The tuner will automatically seek the six strongest
stations in the selected band and memorize them in order of their signal strength.
These stations are automatically placed in the preset memory with the strongest
station in Preset No. 1 and the 6th strongest station in Preset No. 6. When seeking
Stations, the tuner first seeks in the local tuning mode. If less than 6 stations are
memorized, the tuner seeks again in the distance (DX) mode.
4. After finishing the Auto Memory Preset, the tuner goes to the station placed in Preset
Memory No. 1. If no stations are memorized, it returns to the original station you were
listening to before the Auto Memory Preset procedure began.
Preset Tuning
After the preset stations have been memorized, you can tune in your desired station
(within the band displayed) with one touch of a button.
1. Select the tuning band (FM1, FM2, MW or LW) with the TUNER/BAND button ©.
2. Press any one of the Preset buttons () and the number of that preset will illuminate in
the matrix display.
3. The frequency of the station placed in the selected preset location will appear in the
display.
D.A.P. (Direct Access Presets)
This feature allows the storage of FM, MW and LW presets on the same band. Press
the D.A.P. button ® to light up the D.A.P. indicator @. To program stations into the D.A.P.
band, follow steps 1 — 4 as described in the Manual Memory Programming section on
page 14.
Accessing the D.A.P. Presets
1. Press the D.A.P. button @. The D.A.P. indicator @ will illuminate in the display.
2. Press one of the Preset buttons 4).
3. The frequency of the station placed in the selected D.A.P. location will appear in the
display.
Preset Scan
This feature locates the six stations preset in memory on each band and plays 10
seconds of each, in numerical order from Preset No. 1 to No. 6.
1. Select your desired tuning band by pressing the TUNER/BAND button ©).
2. Press the P. SCAN button 6) for more than two seconds.
3. The digital display will indicate the frequency of the preset station tuned in and the
corresponding preset indicator in the display (for each preset 1 through 6) will blink.
For FM presets it will scan FM1, then FM2 and continue to cycle between these two
bands.
4. When your desired preset station is reached, press the P. SCAN button @? for a
second time. The indicator.on the Preset button will stop blinking and the tuner will
remain on the selected station.
15