Alpine 3D Shuttle 7980M - Page 16

@ Traffic Information Receiving
This
model
is
equipped
with
traffic
information
receiving
apparatus
to
be
used
in
West
Germany
where
the
traffic
information
is
broadcast
in
FM.
The
following
is
how
to
use
this
unit
to
receive
traffic
information
broadcasting.
Four
preset
volume
levels
can
be
set
for
traffic
information
reception
in
the
SDK
mode.
Set the
ALARM
LEVEL
selector
switch
on
the
Tuner
Unit
to
the
desired
level.
sift
High «—> Low
NOTE:
When
setting
the
ALARM
LEVEL,
be
sure
to
turn
the
ACC
power
supply
OFF.
Two
ways
are
selectable
when
traffic
information
reception
signal
is
weak
in
the
SDK mode.
1. Press the TUNE switch 2 for 2 seconds.
2.
Press
the
Preset
No.
3
button
@)
to
switch
the
display
between
“ALA”
and
“SRCH".
When
the
ALA
is
selected,
alarm
goes
off
and
when
the
SRCH
is
selected,
other
broadcast
station
is
sought
automatically.
e Radio Mode
1. Select FM position.
2.
Depress
the
SDK
switch
@
and
tune
to
a
station.
If
the
station
is
a
traffic
information
station,
the
SDK
indicator
45
will
glow
and
show
the
reception
of
a
broadcast
from
a
traffic
information
station.
NOTE: SDK Indicator
When
SK
signal
is
received
irrespective
of
the
SDK
switch
position,
the
SDK
indicator will illuminate.
3.
In
the
SDK
mode,
stations
other
than
traffic
information
stations
are
muted
and
cut
out.
Therefore,
it
is
easy
to
select
a
traffic
information
station.
4.
As
the
signal
of
the
tuned
traffic
information
station
becomes
weak,
the
SDK
indicator
will
extinguish.
Then
after
the
lapse
of
25
seconds,
a
rhythmical
alarm
will
sound
to
urge
retuning
to
another
stronger
station.
If
the
reception
of
further
traffic
information
is
required,
tune
in
the
desired
traffic
information
station.
When
received,
the
alarm
will
stop
and
the
SDK
indicator
illuminates.
Since
the
alarm
will
continue
if
no
signals
from
any
other
traffic
stations
can
be
received,
release
the
SDK
switch
for
reception
of
normal
broadcasting.
16