Alpine 425-GRY User Manual

Soap & hand Sanitizer Dispenser
425-GRY, 425-WHI
Installation
1. Please choose a vertical, clean and smooth mounting surface.
2. Make sure there is enough room above dispenser to access cover lock key.
3. Unlock the front cover and take out the soap tank (Fig. 1).
4. Use the back plate for the drill marks and mark the 5 drill locations (Fig. 2).
5. Drill 5 holes at marked locations and insert 5 plastic anchors into drilled holes (Fig. 3).
6. Insert 4 screws into the 4 corner plastic anchors and leave 1/8’’ space from the wall under head for hanging dispenser (Fig. 4).
7. Hang the dispenser on the screws through the keyhole slots at back plate.
8. Insert anti theft screw (Fig. 5).
9. Replace the soap tank and fill it up.
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5
Continue on other side

Alpine 425-GRY Specifications

General

Color	Gray
Material	Plastic
Model	425-GRY
Brand	Alpine
Refillable	Yes
Product Type	Dispenser
Usage	Liquid Soap

Summary

Installation

Surface Preparation and Clearance

Select a suitable vertical surface and ensure adequate clearance for dispenser operation.

Initial Dispenser Setup

Unlock the dispenser, remove the soap tank, and mark drilling locations using the back plate.

Wall Mounting Procedure

Drill holes, insert anchors, place mounting screws, and hang the dispenser securely.

Final Installation Steps

Install the anti-theft screw and refill the soap tank to complete the installation.

Operation and Maintenance

Operating the Dispenser

Select appropriate soap viscosity and fill the tank without overfilling for proper function.

Cleaning and Refilling

Clean dispenser with a dry towel only, use fresh liquid, and clean the container before each refill.

Environmental Precautions

This product is for indoor use only; avoid exposure to direct sunlight to prevent damage.

Product Specifications

Capacity and Viscosity

Details soap tank capacity and the applicable viscosity range for compatible soaps.