Alpine 5953 - Disassembly Instructions; <Audio Box>; <Controller>

| 5953
Disassembly Instructions
<AUDIO BOX>
Hook (A)
1. Removal of Audio P. C. Board
(1) After removal of the bottom cover, remove the
solder (A) and a screw marked “xX” as shown
in Figure 1.
(2) Remove three hooks (A) as shown in Figure 1.
(3) Disconnect all wires from the Audio P. C. Board.
<AUDIO BOX>
Solder (A)
Audio P. C. Board
<CONTROLLER > Figure 1
2. Removal of Nosepiece.
(1) Remove two screws marked “O” as shown in O
Figure 2.
(2) Remove four hooks (B) as shown in Figures 3
and 4,
<CONTROLLER>
3. Removal of Control P. C. Board Bottom s2ic6
(1) After removal of Nosepiece, remove two screws .
:
:
Figure
2
marked “A” as shown in Figure 4. poets
Hook (B) Hook (B) A
Hook (B) Nosepiece Control P. C. Board Hook (B)
}
Figure 3 Figure 4
3
3