Alpine CDA-9835R - Page 9

(3) Control Settings
Power Switch
Fader Control
Balance Control
Treble Control
Bass Contro
MX
(4) Adjustment Procedures
Step
ae Connectio
Description i
Signal Meter
Auto :
Figure 3
Adjustment a
(FM)
Signal Meter
Auto
Adjustment
(MW)
Figure 4
ON
Center Position
Center Position
Center Position
Center Position
Non Effect
T-CORR
CDA-9835R
Test Point /
87.5MHz,
(3)| 21~23dBy
(Mod. OFF)
87.5MHz
Signal Generator Dial Control P.W.Board Adjustment
Coordinates
TP012 Auto Adjustment :
(1) ney , 87.5MHz (3-E) After setting up of Signal Genarator,
(Mod. OFF) TPO11 short GND and TP011 (Pull-Down)
(3-E) for 2~3 seconds.
Proceed same Auto Adjustment of step
(1) under step (2).
87.5MHz, TP012 (SPEC) TP012 : 1.5+0.1V -* OK
(2) 26dBy 87.5MH2 (3-E) (SPEC) TP012 : others 1.5+0.1V —* NG
(Mod. OFF) tren
(3-E) NOTE : NG : Proceed same Auto
TPO12
(3-E)
TPO11
(3-E)
Adjustment of step (1)
under step (3).
Proceed same Auto Adjustment of step
(1) under step (3).
87.5MHz , 4
(4) 26dBy 87.5MHz (3-E) Proceed same Auto Adjustment of step
(Mod. OFF) : TPO11 | (1) under step (4).
(3-E)
999kHz TP012 Auto Adjustment :
(1) 34dBy . 999kHz (3-E) After setting up of Signal Genarator,
(Mod.
OFF)
TPO11
short
GND
and
TP011
(Pull-Down)
; (3-E) for 2~3 seconds.
Proceed same Auto Adjustment of step
(1) under step (2).
999kHz TPO12 | (SPEC) TP012 : 1.00.1V OK
(2)| 34dBy gooktHz (3-E) | (SPEC) TP012 : others 1.0+0.1V + NG
(Mod. OFF) TPO11
(3-E) NOTE : NG : Proceed same Auto.
Adjustment of step (1).
under step (3).
999kHz
,
TPot2
(3)|
29-31dBp
999kHz
(3-E)
Proceed
same
Auto
Adjustment
of
step
(Mod. OFF) TPO11 (1) under step (3).
vee (3-E)
999kHz TPO12
, (3-E) Proceed same Auto Adjustment of step
4 34d 999kH
”
(Mod
ae
TPO11
(1)
under
step
(4).
(3-E)
_TO CONTENTS