Alpine CDE-100 - Sound Setting; Equalizer Presets (Factory EQ); Adjusting Bass, Treble, Balance, and Fader

Sound Setting
Rotary encoder (AUDIO)
Adjusting Bass LevellTreble Levell
Balance (Between Left and Right)/Fader
(Between Front and Rear)
1 Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
BASS
~ TREBLE ~ BALANCE ~ FADER ~ Return to normal
mode
Bass: -12 -
+ 12
Treble: -12 - + 12
Balance: L15 - R15
Fader:
R15 - F15
• I{no operaTion is pel.1lJrll/edjiJl- 5 secol/ds alia se/eclin!i Ihe BASS,
TREBLE. BALANCE
or FADER mode. the unit aUlOlI1tlTically returns
10 I/orma/Illode.
2 Turn the Rotary encoder until the desired sound is
obtained in each mode.
Equalizer Presets (Factory's EO)
6 typical equalizer settings are preset at the factory for a variety of
musical source material.
Press SOUND repeatedly until the desired Factory's EQ
type is displayed.
With each press of the button, the equalizer mode will display the
selected equalizer characteristic.
FLAT(OFF) ~ ROCK --t POP ~ JAZZ --t VOCAL --t CLUB
~ FLAT(OFF)