In
Case
of
Difficulty
CD-R/CD-RW playback not possible.
o Close session (finalization) has not been performed.
- Perform finalization and attempt playback again.
Error displays (built-in CD player only).
• Mechanical error.
- Press
~.
After the
error
indication disappears, insert the disc
3gain.
If
the above-mentioned solution does
not
solve the
problem,
consult
your
nearest Alpine dealer.
CD playback sound
is
wavering.
o Moisture
condensation
in the
CD
Module.
- Allow
enough
time for the condensation to evaporate (about I
hour).
CD insertion not possible.
o A
CD
is already in the
CD
player.
- Eject the
CD
and
remove it.
•
The
CD
is being improperly inserted.
-
Make
sure the
CD
is being inserted following instructions in
the
CD
Player
Operation section.
Unable to fast forward or backward the CD.
•
The
CD
has been damaged.
- Eject the
CD
and
discard it;
using
a
damaged
CD
in
your
unit
C3n
cause
damage
to the mechanism.
CD playback sound skips due to vibration.
•
Improper
mounting
of
the unit.
- Securely
re-mount
the unit.
•
The
disc is very dirty.
- Clean the disc.
•
The
disc
has
scratches.
-
Change
the disc.
o
The
pick-up
lens is dirty.
-
Do
not use a
commercially
available lens
cleaner
disc. Consult
your
nearest
Alpine
dealer.
CD playback sound skips without vibration.
•
The
disc is dirty
or
scratched.
-
Clean
the disc;
damaged
disc should
be
replaced.
CD Player not functioning.
o
Out
of
operating
temperature range
+70°C
(+158°F) for CD.
- Allow the vehicle's interior
(or
trunk) temperature to cool.
Information
Basic
Radio
Unable to tune stations
in
the seek mode.
o
If
the 3rea you are in is 3 primary signal area, the antenna may
not be grounded 3nd connected properly.
-
Check
your
3ntenna connections; make sure the antenna is
properly
grounded
at its mounting location.
o
The
3ntenna may not be the
proper
length.
- Make sure the antenna
is
fully extended; if broken, replace the
antenn3 with a new one.
Broadcast
is
noisy.
o The antenna is not the proper length.
- Extend the 3ntenna fully; replace it if it
is
broken.
o
The
antenna is poorly grounded.
- Make sure the antenna is grounded properly at its mounting
location.
Unable to receive stations.
•
No
antenna
or
open connection in cable.
- Make sure the antenna is properly connected; replace the
antenna
or
cable
if
necessary.
If you encounter a problem, please turn the power off, then on again.
If
the unit
is
still not functioning normally, please review the items
in
the
following checklist. This guide will help you isolate the problem if the
unit
is
at fault. Otherwise, make sure the rest
of
your system
is
properly
connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
- If connected following instructions, the unit will not operate
with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow) connections.
- Check
power
lead and battery lead connections.
• Blown fuse.
-
Check
the fuse
of
the unit; replace with the
proper
value
if
necessary.
MP3, WMA or AAC is not played back.
• Writing
error
occurred.
The
MP3IWMA/AAC
form3t
is
not
compatible.
- Make sure the
MP3IWMA/AAC
has
been
written in 3
supported
format.
Refer
to
"About
MP3IWMAlAAC"
, then
rewrite in the format supported by this device.
To Next Page
Loading...
Need help?
General
