Alpine CDE-100EUB - Technical Specifications; Radio, CD, and USB Specifications

Specifications
FM RADIO SECTION
AM RADIO SECTION
CD PLAYER SECTION
USB SECTION (CDE-100EUB only)
Front AUX input
GENERAL
* CDE-100EUB only
• Due to continuous product improvement, specifications and design
are subject to change without notice.
Tuning Range 87.5-108.0 MHz
Usable Sensitivity 5 dB/µV (S/N 30 dB)
Frequency Response 30-15,000 Hz (±3 dB)
Alternate Channel Selectivity 75 dB
Stereo Separation 30 dB
Image Rejection Ratio 70 dB
IF Rejection Ratio 100 dB
Signal-to-Noise Ratio 62 dB
Tuning Range 531-1,602 kHz
Usable Sensitivity 28 dB/µV (S/N 20 dB)
Sampling Range 8 times oversampling
DA Converter 1 bit DAC System
Pick-up Type 3-beam Photo Detector Pick
Up
Light Source Semiconductor laser
Wave length 790 nm
Laser Power CLASS I
Frequency Response 20-20,000 Hz (±1 dB)
Signal-to-Noise Ratio 96 dB
Total Harmonic Distortion 0.01% (at 1 kHz)
Wow & Flutter Below measurable limits
Channel Separation 85 dB
USB requirements 1.1/2.0 Full Speed
Maximum Supply Compatibility 500 mA
Input Impedance 10 kohms
Allowable external input 2.0 V
Connector 3.5 mm ϕ Stereo mini-pin
Power Requirement 12 V DC (11-16 V allowable),
Test voltage 14.4 V, Negative
ground
Current Consumption Less than 2.1 A (CD mode;
0.5 W × 4)
Maximum Power Output 50 W × 4 (at 1 kHz)
volume control maximum
Power Output 18 W × 4 (1 kHz, 1 %, 4
ohms)
Speaker Impedance 4-8 ohms
Pre-Output Voltage* 2 V (CD mode, 1 kHz, 0dB)
Pre-Output Impedance* 200 ohms
Dimensions (W × H × D) 178 × 50 × 160 mm
Weight 1.2 kg