31-EN
• The iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected (refer to
“
Connections”).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Reset the iPod.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPhone/iPod cable.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
with this unit.
• The iPhone/iPod is not verified.
- Reset the iPod.
- Try another iPhone/iPod, if available.
• Power surge error
Excessive voltage/current is supplied to the iPhone/iPod.
- Try another iPhone/iPod, if available.
• The Bluetooth device is not connected.
- Connect the Bluetooth device.
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to ON (page 20).
If the above solution does not work, consult your nearest
dealer.
Indication for iPod Mode
Bluetooth mode
Indication for all Modes
To Next Page
Loading...
