Alpine CDE-133EBT User Manual

8-EN
Presetting Stations Automatically
1 Press BAND repeatedly until the desired radio band is
displayed.
2 Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
1 Press BAND repeatedly until the desired band is
displayed.
2 Press any one of the station preset buttons (1 through 6)
that has your desired radio station in memory.
The display shows the band, preset number and frequency of
the station selected.
Frequency Search Function
You can search for a radio station by its frequency.
1 Press ENTER in Radio mode to activate Frequency
search mode.
The “” indicator lights up.
2 Turn the Rotary encoder to select the desired frequency.
3 Press ENTER to receive the selected frequency.
Note
• Press  in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
Playback
1 Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Note
• When a disc is already inserted, press SOURCE to switch to the
DISC mode.
2 While playing back MP3/WMA, press 1 or 2 to select
the desired folder.
Pressing and holding 1 or 2 will change folders continuously.
3 Press  or  to select the desired track (le).
Pressing and holding  or  will fast backward/fast
forward track continuously.
4 To pause playback, press .
Pressing  again will resume playback.
5 To eject the disc, press .
Notes
• Do not remove a CD during its eject cycle. Do not load more than one
disc at a time. A malfunction may result from doing either.
• e “” indicator lights up when a disc is inserted.
• ree-inch (8 cm) CDs can not be used.
• Any le protected by DRM (Digital Rights Management) copy
protection, cannot be played back on this unit.
• e track display for MP3/WMA data playback is the le numbers
recorded on the disc.
• e playback time may not be correctly displayed when a VBR
(Variable Bit Rate) recorded le is played back.
• During CD/MP3/WMA playback, press , and then you can quickly
return to the hierarchy level selected last time in the search mode.
CD/MP3/WMA


SOURCE/

Rotary encoder
/ENTER


1
2

4 5

Alpine CDE-133EBT Specifications

General

Brand	Alpine
Model	CDE-133EBT
Category	Car Receiver
Language	English