Alpine CDE-133EBT User Manual

4-EN
disc has been inserted correctly, push the RESET button with a
pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc or damage the player.
New Discs
To prevent the CD from jamming, “ERROR” is displayed if discs
with irregular surfaces are inserted or if discs are inserted
incorrectly. When a new disc is ejected immediately aer initial
loading, use your nger to feel around the inside of the centre hole
and outside edge of the disc. If you feel any small bumps or
irregularities, this could inhibit proper loading of the disc. To
remove the bumps, rub the inside edge of the hole and outside edge
of the disc with a ballpoint pen or other such instrument, then
insert the disc again.
Irregular Shaped Discs
Be sure to use round shape discs only for this unit and never use any
special shape discs.
Use of special shape discs may cause damage to the mechanism.
Installation Location
Make sure this unit will not be installed in a location subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
Correct Handling
Do not drop the disc while handling. Hold the disc so you will not
leave ngerprints on the surface. Do not ax tape, paper, or
gummed labels to the disc. Do not write on the disc.
Disc Cleaning
Fingerprints, dust, or soil on the surface of the disc could cause the
CD player to skip. For routine cleaning, wipe the playing surface
with a clean, so cloth from the centre of the disc to the outer edge.
If the surface is heavily soiled, dampen a clean, so cloth in a
solution of mild neutral detergent before cleaning the disc.
Disc Accessories
ere are various accessories available on the market for protecting
the disc surface and improving sound quality. However, most of
them will inuence the thickness and/or diametre of the disc. Using
such accessories can cause the disc to be out of standard
specications and may create operational problems. We
recommend not using these accessories on discs played in Alpine
CD players.
On handling Compact Discs (CD/CD-R/CD-RW)
• Do not touch the surface.
• Do not expose the disc to direct sunlight.
• Do not ax stickers or labels.
• Clean the disc when it is dusty.
• Make sure that there are no bumps around the disc.
• Do not use commercially available disc accessories.
Do not leave the disc in the car or the unit for a long time. Never
expose the disc to direct sunlight. Heat and humidity may damage
the CD and you may not be able to play it again.
To customers using CD-R/CD-RW
• If a CD-R/CD-RW cannot be played back, make sure the last
recording session was closed (nalised).
• Finalise the CD-R/CD-RW if necessary, and attempt playback again.
About media that can be played
Use only compact discs with the label side showing the CD logo
marks below.
If you use unspecied compact discs, correct performance cannot
be guaranteed.
You can play CD-Rs (CD-Recordables)/CD-RWs
(CD-ReWritables) which have been recorded only on audio devices.
You can also play CD-Rs/CD-RWs containing MP3/WMA
formatted audio les.
• Some of the following CDs may not play on this unit:
Flawed CDs, CDs with ngerprints, CDs exposed to extreme
temperatures or sunlight (e.g. le in the car or this unit), CDs
recorded under unstable conditions, CDs on which a recording failed
or a re-recording was attempted, copy-protected CDs which do not
conform to the audio CD industry standard.
• Use discs with MP3/WMA les written in a format compatible with
this unit. For details, refer to “About MP3/WMA” on page 10.
• ROM data other than audio les contained in a disc will not produce
sound when played back.
Centre Hole
Centre Hole
New Disc
Outside
(Bumps)
Bumps
CORRECT
TCERROCTCERROCNI
Transparent Sheet Disc Stabilizer

Alpine CDE-133EBT Specifications

General

Brand	Alpine
Model	CDE-133EBT
Category	Car Receiver
Language	English