Alpine CDE-170 - Page 14

14-EN
ALPINE CDE-170 68-40368Z01-B (EN) 128x182
Playb
Playin
g
170 on
1 Insert
Playba
Playing
In these O
a general
iPod and
i
the text o
available
o
For details
“About iPo
(page26).
AOA (And
Storage C
type USB
d
standard c
device, th
can be sel
Some dig
i
smartpho
* e.g., a USB
smartpho
Notes
• For details
consult y
• Smartpho
support A
However,
AOA 2.0 e
For detail
s
smartpho
Notes
• The activation process usually takes 10 to 15 minutes,
but may take up to an hour.
• Your radio will need to be turned on and receiving the
SiriusXM signal to receive the activation message.
Selecting channels for SiriusXM
1 Press (browse).
2 Rotate the control dial to select
[CHANNEL], then press it.
3 Rotate the control dial to select the
desired channel, then press it.
To select channels from categories
1
Press (browse).
2 Rotate the control dial to select [CATEGORY], then
press it.
3 Rotate the control dial to select the desired
category, then press it.
The channel list appears.
4 Rotate the control dial to select the desired
channel, then press it.
To store channels
1 While receiving the channel that you want to
store, press and hold a number button (1 to 6)
until [MEM] appears.
To receive the stored channel, press /A.ME to
select [SX1], [SX2] or [SX3], then press a number
button (1 to 6).
To set a parental control
The parental control feature allows you to limit
access to SiriusXM channels with mature content.
When enabled, the parental control feature
requires you to enter a passcode to tune to the
locked channels. Information on setting up the
passcode and locking channels can be found
below.
1 Press and hold /SETUP for at least 2 seconds
and rotate the control dial.
2 Select [GENERAL] [SXM PARENTAL]
[LOCK SELECT]
[LOCK ON].
3 Enter the passcode by rotating the control dial on
the unit.
To move the entry position, press / on the
unit.
The initial passcode is [0000].
4 After entering the passcode, press ENTER.
To unlock the channels, select [LOCK OFF].
To change the passcode
1
Press and hold /SETUP for at least 2 seconds
and rotate the control dial.
2 Select [GENERAL] [SXM PARENTAL] [CODE
EDIT].
3 Enter the current passcode on the current
passcode input display, then press ENTER.
The initial passcode is [0000].
4 Enter your new 4-digit passcode on the new
passcode input display, then press ENTER.
To change display items
Press VIEW to change as follows:
Channel Number (Default)
Channel Name
Artist Name
Song Title Content Info
Category Name
Clock