Alpine CDE-170 - Installation Procedures

41-EN
ALPINE CDE-170 68-40368Z01-A (EN) 128x182
EN
FR
ES
Installing the microphone (CDE-172BT/
UTE-73BT only)
To capture your voice during handsfree calling,
you need to install the microphone
.
Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or
gearshift. Be sure to keep it and other parts
from interfering with your driving operations.
• If airbags or any other shock-absorbing
equipment is in your car, contact the store
where you purchased this unit, or the car
dealer, before installation.
Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Installation
Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar
and the bracket from the unit.
1 Pinch both edges of the protection collar
, then pull it out.
2 Insert both release keys until they
click, and pull down the bracket
, then
pull up the unit to separate.
Face the hook inwards.
Mounting the unit in the dashboard
• Before installing, make sure the catches on
both sides of the bracket
are bent inwards 2
mm (/ in).
• For Japanese cars, see”Mounting the unit in a
Japanese car” (page42).
1 Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.