EasyManua.ls Logo

Alpine CDE-9846RM - CD Player Status and Specifications; CD Player Indication Meanings; Technical Specifications

Alpine CDE-9846RM
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19-EN
Indication for CD Player
HI TEMP
Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature
returns to normal operating range.
NO DISC
No CD is inserted.
- Insert a CD.
Although a disc is inserted, “NO DISC” is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the c button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
ERROR
Mechanism error.
1) Press the c button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
c button again.
If the error indication still does not turn off after pressing
the c button for a few times, consult your Alpine dealer.
When “ERROR” is displayed:
If that the disc cannot be ejected by pressing c, press the
RESET switch (refer to page 5) and press c again.
If the disc still cannot be ejected, consult your Alpine dealer.
•A disc that is not compatible with the unit is inserted.
- Insert a disc that is compatible with the unit.
UNSUPORT
The disc is not written in a MP3 supported format.
- Use a disc written at the MP3 supported format.
Specifications
FM TUNER SECTION
Tuning Range 87.5 – 108.0 MHz
Mono Usable Sensitivity 0.7 µV
Alternate Channel Selectivity 80 dB
Signal-to-Noise Ratio 65 dB
Stereo Separation 35 dB
Capture Ratio 2.0 dB
MW TUNER SECTION
Tuning Range 531 – 1,602 kHz
Sensitivity (IEC Standard) 25.1 µV/28 dB
LW TUNER SECTION
Tuning Range 153 – 281 kHz
Sensitivity (IEC Standard) 31.6 µV/30 dB
CD SECTION
Frequency Response 5 – 20,000 Hz (±1 dB)
Wow & Flutter (% WRMS) Below measurable limits
Total Harmonic Distortion 0.008% (at 1 kHz)
Dynamic Range 95 dB (at 1 kHz)
Signal-to-Noise Ratio 105 dB
Channel Separation 85 dB (at 1 kHz)
PICKUP
Wave length 795 nm
Laser power CLASS I
GENERAL
Power Requirement 14.4 V DC
(11–16 V allowable)
Maximum Power Output 45 W × 4
Maximum Pre-Output Voltage 2 V/10k ohms
Bass +20/-14 dB at 60 Hz
Treble ±14 dB at 10 kHz
Weight 1.6 kg (3 lbs. 8 oz)
CHASSIS SIZE
Width 178 mm (7")
Height 50 mm (2")
Depth 160 mm (6-1/4")
NOSEPIECE SIZE
Width 170 mm (6-3/4")
Height 46 mm (1-13/16")
Depth 18 mm (11/16")
Due to continuous product improvement, specifications and design
are subject to change without notice.
CAUTION
(Bottom side of player)
CLASS 1
LASER PRODUCT

Table of Contents

Related product manuals