Alpine CDM-7859RB - Page 60

CDA-7873R
1/0 Terminal Description
GND connect terminal
Reset input terminal from CD Signal Processor LS! block. (L:Reset)
IOSEL (GND)
a
TRH
ix
Bit Clock output terminal for SRDATA.
L/R discrimination signal output terminal. Pas
SRDATA
SUBC (NC)
SBCK (GND)
DOSY (NC)
DEMPH (NC)
Serial Data output terminal.
No connect terminal
GND connect terminal
No connect terminal
Digital Audio interface signal output terminal
PSEL (GND)
MSEL (GND)
SSEL (BATT+5V)
po emct twmi
BATT+5V connect terminal
DVSS1
SC
0SC2
2 =
Power supply terminal for digital circuit.
Main Clock output terminal. (f=16.9344MHz)
Main Clock input terminal. (f=16.9344MHz)
iS)
"a
o
Mecha control SW input terminal. (L:SW ON)
Pick-Up inner detect SW input terminal. (L:detector)
Digital Audio Data contro! output terminal. (H:D/0 ON)
D/OCNT
RF-GAIN(NC)
LODM+
0
ZMUTE
SITMIMENMITNMENINENITNEN an for mor on oi
ili
fe Sle cetera |i
¥
Loading Motor control terminal.
fom
Qo
DATA
LATCH
CLOCK
RQ
Status Request signal output terminal
-COM block reset terminal.
STBY signal input terminal.
n
STBY
wo oioc foe)
no19d
5142
on =
Te) wo als
SCK
Power supply terminal for A/D converter
Rech Audio output terminal
Power supply terminal for analog circuit.
(for Audio output block (for using both as Lch and Rch))
VREF+
OUTR
AVDD1
wo o
™ nn
Leh Audio output terminal
GND connect termina! for analog circuit.
(for Audio output block (for using both as Lch and Rch))
OU a
100 AVSS1