Alpine CVA-1004 - Monitor and Sound Guide Settings; Automatic Monitor Opening;Closing; Sound Guide Function Activation

32-EN
Setting Automatic Opening/
Closing of Monitor
You can set the monitor to open or close
automatically or manually.
After carrying out steps 1 to 3 of "To display the
SETUP screen" (page 29), perform the operation
shown below.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 2 to activate the GENERAL setting
mode. Press preset 2 again to select MONITOR
O/C.
3 Press g or f to set the Auto Opening
mode.
FULL:
The monitor automatically opens or closes
when the ignition key is turned to ACC/ON or
OFF.
CLOSE:
The monitor automatically closes when the
ignition key is turned to OFF. The monitor
opens manually when OPEN/CLOSE is
pressed.
MANUAL:
Press OPEN/CLOSE to manually open or
close the monitor.
For any other settings, press preset 2 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
Turning Sound Guide Function On
or Off
The Sound Guide function will give audible
feedback with a beep sound when a button on the
unit is pressed to acknowledge the receipt of the
signal from the button.
After carrying out steps 1 to 3 of "To display the
SETUP screen" described on (page 29), perform
the operation shown below.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 2 to activate the GENERAL setting
mode. Press preset 2 again to select BEEP.
3 Press g or f to select ON or OFF.
ON: The unit beeps when a button is pressed.
OFF: No beep sound.
For any other settings, press preset 2 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
gg
gg
g
ff
ff
f
Preset 2
MUTE/
SETUP
Other Useful Features
→ FULL ↔ CLOSE ↔ MANUAL ←
TITLE
OPEN/CLOSE
--
--
-/
JJ
JJ
J