Jeep Wrangler
WRANGLER 14/22
i209-WRA Wiring Diagram
To Vehicle Connectors
CAN I/F
GPS
USB
EXT. KEY W.REMOTE POWER
SXM/DAB
PRE OUT
DISP. OUT
HDMI IN HDMI OUT
ANTENNA
Direct Camera Input
Connect to SXM adapter
For DVD player (NOT INCLUDED)
Direct Camera Adapter
i209 - Source Unit
Power Harness
i209D - Display
Front
Rear
Rear
Front
For factory amplified vehicles switch the
speaker connectors, front to rear and
rear to front.
AMPLIFIED VEHICLES
Failure to follow this procedure will
result in no audio from Navigation and
Bluetooth sources.
Microphone
WARNING!
iDatalink MAESTRO Module
18-pin Black
Connector
10-pin Black
Connector
3-pin Black
Connector
(Audio)
10-pin Green
Connector
(Vehicle signals)
3-pin Black
Connector
(Power)
4-pin Black
Connector
(Data)
Blue Power Antenna
Blue/White Amp Turn-on
AUX Power
3-pin Black Connector
Black - Ground
Yellow -12V+
Red - Acc 12V+
To OBDII Connector
Power/Speaker
16-pin Green Connector
OEM Audio
20-pin Gray
Connector
HDMI Interface
6-pin White Connector
Front
Rear
Rear
Front
Rear View Camera
6-pin Black Connector
White/Gray Manual Transmission Reverse Input
For manual transmission vehicles ONLY. Connect the
White/Gray wire to the White/Gray wire located
on the passenger side kick panel.
Rear View Camera
WARNING!
The use of this connection
is intended for Alpine
HCE-TCAM1-WRA rear
view camera ONLY.
MANUAL TRANSMISSION VEHICLES
Cut loop when connecting
KCX-630HD HDMI selector
interface.
18-PinChime10-Pin
Red
Not
Used
Reset
Button
If using
KAC-001
see page 19
3-Pin 4-Pin 3-Pin 4-Pin10-Pin
Blue
Not
Used
*
Not
Used
If using
HCE-TCAM1-WRA
see page 18
Main Harness
Rear
To Next Page
Loading...
