4 When the software update is finished, the Alpine Head Unit restarts automatically.
Keep the USB stick inserted for next update process.
i902D-(OC3, G7, G6, DU) / iLX-702D / iLX-702E46 / iLX-702LEON
software update procedure
USB connector
Notes
• Do NOT use the compressed file for update, otherwise the Unit cannot recognize the files.
• Do NOT change folder name and file names, otherwise the Unit cannot recognize the files.
• Do NOT store the folder inside another folder.
• Do NOT store any other folders/files on the USB device.
• Do NOT remove the USB device while updating.
• Do NOT update while driving.
• Do NOT press any buttons while updating.
• Do NOT turn off vehicle’s ignition or head unit’s power switch while updating.
Moder
n vehicles will shut down the ignition (ACC) after some time if the engine is not running.
If you are not sure if this applies to your car, leave the engine idling while the update is in progress.
3 Press “OK” button when update message appears on the screen.
Alpine Head Unit
Install update software
1 Store the downloaded and extracted files “xxxx_USBStick-1_Audio.zip“ on the empty
USB device in the Root Folder (see left figure).
2 Connect USB device to USB connector of the Alpine Head Unit.
Please see lower left figure.
* Please wait update Start for 20 seconds.
Update will be completed in around
3 minutes.
Update procedure Audio Step 1
Connection
USB device
USB extension cable
6 Remove the USBStick-1 first. Then press “OK” button. It takes a few seconds for restart.
Step 1 is now finished. Now go to Step 2, “xxxx_USBStick-2_Audio.zip“ Update.
5 Press “OK” button when update message appears on the screen.
Update will be completed in around
1 minute.
Alpine iLX-702D: RE00010A
Alpine iLX-702E46: RE00010A
Alpine iLX-702LEON: RE00010A
Alpine i902D-G7: WE00010A
Alpine i902D-G6: WE00010A
Alpine i902D-OC3: WE00010A
Alpine i902D-DU: WE00010A
The Audio Software must be updated in two steps. First, please download the
“xxxx_USBStick-1_Audio.zip” and follow the instructions. The i902D-xx/iLX-702xx can be
updated via USB connection (see connection diagram below). Before starting to update,
please check following notes. The download file is compressed in zip format. The contents
of the download need to be extracted to a freshly formatted USB device (FAT32).
Update file contents / storage place (for each type of unit)
Root
ALPS ALPINE EUROPE GmbH, Alpine Brand
To Next Page
Need help?
General
Weight and Dimensions
