29-EN
Displaying Software License
Setting contents:
Open-Source Software License
Initializing the Sound Settings
You can restore the EQ Setting*/X-OVER*/Time Correction*/
Media Xpander (MX)/bass engine/Subwoofer to factory
settings.
1 Touch [Set] of “Default Sound Settings”.
2 After the confirmation message appears,
touch [OK].
The system starts initialization.
∗ The setting values that are stored in Preset 1 to
Preset 3 cannot be initialised.
Initializing the System
You can initialize all data, to restore the factory settings.
Remove the USB flash drive, etc. from the system before
operation.
1 Touch [Reset] of “Clear All Settings”.
2 After the confirmation message appears,
touch [OK].
The confirmation screen appears.
3 Touch [OK].
The system starts initialization.
• Do not turn on/off the power, change the ignition key position,
until system restart is completed.
Sound Setup
You can set up items related to the sound quality.
Touch the upper central area [ ] of the Home
screen.
The Sound Setup screen is displayed.
• The Sound Setup screen can also be displayed by touching
[
] (HOME) while displaying the Home screen.
■
Sound Setup Menu screen
Current source information display.
Touch this to change to the Home screen.
X-OVER (page 32)
Voltage display.
bass engine (page 33)
Volume level indicator
Time Correction (page 32)
Defeat (page 34)
Tone Adjust (Bass/Treble) (page 33), Sub
Woofer Level (page 33)
EQ Setting (page 30)
Media Xpander (page 30)
Fader/Balance/Rear Speaker/Subwoofer (page
31)
To Next Page
Loading...
