24-EN
Graphic Equalizer Curve Settings
(Graphic EQ)
[Graphic EQ] is selected on the Sound Setup Menu screen.
You can modify the Equalizer settings to create a response
curve more appealing to your personal taste.
Setting item:
Graphic EQ
Setting contents:
-7 to 7
• This setting is only available when “Defeat” is set to [On]
(page 26).
1 Touch [Graphic EQ] on the Sound Setup menu
screen.
2 Touch the band to be adjusted.
3 Touch [ ] or [ ] to adjust the level of the
band.
• You can also adjust the level of the band by moving
the slider.
4 To adjust another band, repeat step 2 to 3,
and adjust all bands.
5 To store the adjusted setting value, touch and
hold [Preset 1], [Preset 2], or [Preset 3] for at
least 2 seconds.
• Settings exceeding the frequency of adjacent bands are not
available.
• While adjusting the Graphic EQ, you should consider the
frequency response of the connected speakers.
• When the Graphic EQ is adjusted, the Equalizer Presets are
overridden.
• When Equalizer Presets is set, the linked Graphic EQ settings
are also changed. We recommend storing Graphic EQ settings
in a Preset in advance.
• Tou ch [ Flat] to initialize all values.
Calling the Graphic EQ adjusted value
Touch [Preset 1], [Preset 2], or [Preset 3].
The setting stored in the Preset will be recalled.
Time Correction Settings
[Time Correction] is selected on the Sound Setup Menu
screen.
Before performing the following procedures, see “About
Time Correction” (page 27).
Correction mode
Setting item:
Time Correction
1 Touch [Time Correction] on the Sound Setup
menu screen.
2 Touch the Correction mode button, and then
select [ms], [cm] or [inch].
3 Touch [
] or [ ] for each speaker to adjust
the time or distance.
0.0 msec to 9.9 msec (0.1 msec/step)
0.0 cm (0.0 inch) to 336.6 cm (132.56 inch) (3.4 cm/step)
All speaker setting values are adjustable in the range of
20 ms or 680 cm.
4 To store the adjusted setting value, touch and
hold [Preset 1], [Preset 2], or [Preset 3] for at
least 2 seconds.
• Tou ch [ Flat] to set all values to 0.0.
• If the Rear Speaker setting is Off, the Rear Speaker setting
cannot be edited (page 26).
• If the Subwoofer setting is Off, the Subwoofer setting cannot be
edited (page 26).
Calling the Time Correction Value
Calling the pre-set time correction value.
Touch [Preset 1], [Preset 2], or [Preset 3] on the time
correction screen.
The setting stored in the Preset will be recalled.
To Next Page
Loading...
