Alpine INE-W957E - Setting a New Starting Position for the Route

51
Tap to append the newly selected destination at the end of the route. The
other destinations of the route remain intact. The previous final destination is now the
last waypoint.
3.4.2 Setting a new starting position for the route
For normal navigation, all routes are planned from the current position. In order to check
future routes, simulate them or see their length in time and distance, you can turn off the GPS
receiver. Then you can set the starting point of the route to a different location than the
current GPS position.
1. In the Navigation menu, tap
.
2. If you already have a route, tap
. If you are starting a new route, tap .
3. The first line is the start of the route, normally the current GPS position. Tap and
confirm your action at the warning message.
4. The Destination menu appears and you can select the start point of the route the same
way you select a destination.