Alpine INE-W960A - About INE-W960 A;INE-W960 E; Switching Display Modes; Adjusting Brightness; Adjusting Colour of Picture

28-EN
01GB04INE-W960E.fm
ALPINE INE-W960A/INE-W960E INE-W960E_OM (EN)
Setting item: Display Mode
Setting contents: FULL (Initial setting) / NORMAL
In FULL mode, the monitor displays a normal picture wider to fit
in a wide-screen monitor.
In NORMAL mode, the monitor displays a normal picture at the
centre of the screen with a vertical black band at each side.
Setting item: Brightness
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the brightness between MIN (-15) and MAX
(+15). When it reaches the minimum or maximum point, the
display shows “MIN” or “MAX” respectively.
Setting item: Color
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the colour between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows “MIN” or “MAX” respectively.
Setting item: Contrast
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the contrast between LOW (-15) and HIGH (+15).
When it reaches the minimum or maximum point, the display
shows “LOW” or “HIGH” respectively.
About INE-W960A/INE-W960E
[About] is selected on the General setup menu in step 3. Refer to
“General Setup Operation” (page 25).
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support or
an Alpine-authorised dealer.
Setting item: Version Info
Contents: Serial No. / Firmware Version
This unit will display the registration code required to play a DivX
®
VOD (Video On Demand), or you can also display the deregistration
code.
Setting item: Warranty / Copyright Info.
Displaying the Registration Code
1 Touch [Warranty/Copyright Info.].
2 Touch [DivX(R) VOD].
3 Touch [Registration].
The registration code is displayed on the screen.
4 Touch [OK].
Displaying the Deregistration Code
1 Touch [Warranty/Copyright Info.].
2 Touch [DivX(R) VOD].
3 Touch [Deregistration].
The confirmation dialog screen appears.
4 Touch [OK].
The deregistration code is displayed on the screen.
• When you have finished, touch [Cancel]. If you want to continue and
display a new registration code, touch [OK], check the registration
code, and then touch [OK] again.
You can initialise all data, to restore the factory settings. Remove the
CD/DVD disc, etc. from the system before operation
Setting item: Restore Factory Setting
1 Touch [Restore Factory Setting].
2 After the confirmation message appears, touch
[OK].
The confirmation screen appears again.
3 Touch [OK].
The system starts initialisation.
• Do not turn on/off the power or change the ignition key position until
system restart is completed.
• If you perform this setting, the On/Off setting of Security Code
(page 29) is not initialised.
Switching Display Modes
Adjusting Brightness
Adjusting Colour of Picture
Adjusting Image Contrast
Displaying the Product Information
Checking the DivX
®
Registration
Initialising the System
01GB00INE-W960E.book Page 28 Wednesday, November 19, 2014 5:31 PM