Alpine PSS-22WRA - Speaker Installation; Front Tweeter Installation (2011-2014); Front Tweeter Installation (2015-2018); Front Woofer Installation (2011-2018)

1
Select the (2011-2014) crossover input wires and
connect to the vehicle plug. Connect tweeter
connectors. Secure the crossover.
Note: 2015-2017 input plug is not used.
2
Guide the tweeter in the opening and press into
place.
Front Speaker (Tweeters) Installation 2011 – 2014 Models
1
Remove the speaker by extracting the (3) factory
screws. (Save screws for later). Cut a slit in the center
of the polyfill, and pull the vehicle plug through. Insert
the excess polyfill into the enclosure. Note:
Installation of polyfill is needed for optimum
sound.
2
Add the foam strip, connect the vehicle plug to the
speaker.
1. Install using the reverse procedure
2. Repeat for the opposite side
Front Speaker (Woofers) Installation 2011 – 2018 Models
Add foam strip
(included)
Do not use
(2015-2017)
2007-2014
Connect the tweeter (-)
to the crossover and
select either:
0db wire
+3db wire
(Increased TW level)
for the tweeter (+) lead
(-)
(+)
(+)
TW level
TW level
+3db
0db
1
Press the tweeter into the 3.5” tweeter adapter.
2
Front Speaker (Tweeters) Installation 2015 – 2018 Models
Do not use
(2015-2017)
2007-2014
Connect the tweeter (-)
to the crossover and
select either:
0db wire
(Default TW level) or
+3db wire
(Increased TW level)
for the tweeter (+) lead
(-)
(+)
(+)
TW level
TW level
+3db
0db
Select the (2015-2018) crossover input wires and
connect to the vehicle plug. Connect tweeter
connectors. Secure the crossover.
Note: 2011-2014 input plug is not used.
Insert Polyfill
Jeep Wrangler
UNLIMITED JK • 13/19