Alpine TDM-7529T User Manual

TDM-7529T/F
TDM-7526T/W/F
(2) Control Settings
Power Switch ou...
Fader Control
Balance Control
Treble Control on... cece
Bass Control wee
Others
(3) Adjustment Procedures
Description | Test Tape |
MTT-141N
(1kHz)
MTT-144
(10kHz)
MTT-144
(10kHz)
MTT-141N
(1kHz)
Dolby Level
Adjustment
(0, O)
MTT-150
(400Hz)
MTT-111N
(kHz)
sevebibupubvensenaeereeeyareaece ON
Center Position
Center Position
ssetvetasdustes’ Center Position
eee Center Position
seh end rd £0 Mee a OFF
Head height
Figure 12 parr Adjustment Screw
A (Figure 14)
Head Azimuth
Figure 12 Adjustment Screw
B (Figure 14)
Par Spades Head Azimuth
Output
Adjustment Screw
Figure 12
C (Figure 14)
ef
T.P.8 (Loh)
T.P.9 (Roh)
VR101 (Loh)
VR102(Rch)
Figure 13
Tape Speed
Adjustment
(Figure 15)
Speaker
Figure 12
Output
(Lch or Roh)
Notes : © : For TDM-7529T Model only, @ : For TDM-7529F Model only ,
-~16-
Adjustment
Adjust until the Rch level obtains the
Max. output with the test tape A-side
played back in the reverse mode.
Adjust for Max. and same level output
of Lch and Reh at Forward mode.
Adjust for Max. and same level output
of Lch and Rch at Reverse mode.
Confirm Lch and Reh output level
difference is more than 42dB with the
test tape A-side played back in the
reverse mode.
Proceed the same procedure as above
with the test tape A-side played back
in the reverse mode, B-side in the
forward mode, and B-side in the
reverse mode.
Adjust for 245mV +0.5dB at TP.8
(Lch) and T.P.9 (Rh).
Adjust for 2,970 to 3,090 Hz at
Speaker Output.
Others : Common.

Alpine TDM-7529T Specifications

General

Brand	Alpine
Model	TDM-7529T
Category	Car Receiver
Language	English