4-EN
Basic Operation
Screen Display ON/OFF
1 Press the POWER button.
2 To turn off the POWER, press the POWER
button again.
• If properly connected, the monitors main
POWER will turn off when the vehicle's
ignition switch is off.
• After turning the system off, a slight ghost of
the image will remain temporarily. This is an
effect peculiar to LCD technology and is
normal.
• Under cold temperature conditions, the
screen may lose contrast temporarily. After a
short warm-up period, it will return to
normal.
Adjusting the Volume
1 Adjust the volume level by pressing the or
button.
Switching the Source
Press the SELECT button.
Each press of the button will cycle through the modes as
follows:
1 If AUX3 SELECTION S/W of Black Box is
• "IN" position
AUX1 AUX2 AUX3
• "OUT" position
AUX1 AUX2
2 If current screen mode is AUX3, and AUX3
SELECTION S/W is switched to "OUT" then
screen mode will be changed AUX1.
SELECT
POWER
DISP
1 EN TME-M780&TME-M780EM.pmd 3/2/2006, 5:20 PM4
To Next Page
Loading...
