48
Composite Wire Connection Instructions
In order to prevent external noise interference on the audio system：
• The installation position of this Media Player and the arrangement of wires should be at least 10cm away from
the car wiring harness.
• Keep the battery power cord as far away from the other wires as possible.
• Connect the ground wire firmly to the bare metal contact of the vehicle chassis (remove any paint, dirt or
grease if necessary).
• If you are attaching an optional noise suppressor, connect it as far away from the unit as possible. Various
types of noise suppressors are available from your Alpine dealer; please contact him or her for details.
• Your Alpine dealer is proficient in noise prevention methods, please consult your dealer for details.
On-board CD/DVD
player
On-board DSP DS
Control box
External amplifier
Active
subwoofer
1
○
AUX-IN： Low level input, can be connected to the car CD/DVD player.
2
○
SUBW-OUT： Ultra-low output, can be connected to active subwoofer.
3
○
REAR-OUT： Rear RCA output, can be connected to an external amplifier.
4
○
FRONT-OUT： RCA output of the front sound field, which can be connected to an external power amplifier.
5
○
ADC SWC： ADC type steering control interface, supports resistive control of car steering wheel.
6
○
DECODING SWC：Decoding steering control interface (temporarily not supported, based on the recent upgrade).
7
○
ALPINE SYSTEM：Can be used to connect to the Alpine on-board DSP, only supports the products which
can be docked by the controller interface, such as PXE-R600, PXE-0850X. or PXE-X09, etc.
8
○
9
○
OPTICAL-OUT/COAXIAL-OUT：Optical / coaxial interface, can be connected to the car DSP, such as
PXE-0850X or PXE-X09 and so on.
To Next Page
Loading...
