Alstom DS Agile C26 Series - Firewall Usage Requirements; Firewall Configuration via SCE; SCS Level Firewall Settings

12 pages

To Next Page

To Previous Page

Addendum to Technical Manual DS Agile C26x

AD-4 C26x/EN AD/C67

2 FIREWALL USAGE REQUIREMENTS

Firewall usage requirements for network separation on the C26x BCU are:

 Different subnet IP addresses on Eth1 and Eth2.

(Default subnet mask is 255.255.255.0).

 Operational database.

Note:

Firewall usage is configured only in Off-line mode through the SCE.

2.1 FIREWALL USAGE SCE CONFIGURATION

Configure the Firewall usage in SCE.

During the configuration this parameter can be set to:

 Yes (Enabled)

 No (Disabled)

2.1.1 SCS LEVEL

SCS level set the value of attributes Firewall Usage:

W0410ENa