© ALSTOM 2010. All rights reserved. Informat
this document is indicative only.
No representation or warranty is given or
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
change without notice. Reproduction, use or disclosure to
third parties, without express writt
Before re-installing of covers :
check inside encolure cleanness, no outsider body (tools, pieces...).
Cleen and sweep up hoover enclosure inside.
Re-install of covers with tighten the screws to their required torque, and pro-
ceed with preparation of electrical contacts (see ...31--501).
To Next Page
Loading...
